Nissan Quest 1999

Procedure

OPEN the vehicle and enter, then CLOSE and LOCK all doors.

Slowly INSERT and REMOVE ignition key 6 times within 10 seconds.

NOTE : DO NOT turn key, just insert fully and remove.

The TAIL LIGHTS will flash to indicate all existing remote transmitters have been erased

TURN ignition switch to the ACC position.

Press any button on the 1^st remote transmitter to be programmed.

The HAZARD lights will flash to confirm programming.

To program additional remote transmitters, UNLOCK and LOCK the doors using the power lock switch located on the drivers door.

Press any button on the 2^nd remote transmitter.

NOTE : UP to 4 remote transmitters can be programmed.

Repeat steps 8 and 9 for any additional remote transmitters.

Open drivers door, and switch ignition OFF to end programming.