Free, program your remote

                                 Toyota Highlander 2nd. Gen. 2008-2013



NOTE : Make sure the drivers door is OPEN and UNLOCKED and all other doors are CLOSED and the key is out of the ignition.

 

INSERT and REMOVE the key from the ignition key cylinder twice within 5


CLOSE and OPEN the drivers door TWICE within 40

 

INSERT the key into the ignition key cylinder and remove it.

 

CLOSE and OPEN the drivers door TWICE within 40 seconds again.

 

Insert the key into the ignition key cylinder.

 

CLOSE the drivers

 

Within 40 seconds switch ignition ON and OFF :-

 

ONCE time to program remote key transmitter but keep existing remotes programmed.

            TWICE to program remote key transmitter but erase all existing remotes.

            THREE times to CHECK how many key transmitters are programmed.

            FIVE times to ERASE ALL remote key transmitters.

 

REMOVE the key from the ignition key cylinder.

 

To CONFIRM your selection the power locks will now cycle LOCK to UNLOCK a number of times corresponding to your key cycles.

 

To PROGRAM the remote key transmitters PRESS and RELEASE LOCK and UNLOCK buttons at the same time for 1.5 seconds.

 

Within 3 seconds PRESS the LOCK and UNLOCK

 

The vehicle will LOCK and UNLOCK to CONFIRM

 

Within 40 seconds REPEAT for all remote transmitters to be programmed.

 

NOTE : The vehicle will LOCK and UNLOCK twice if it has failed to register the remote transmitter.

 

OPEN the drivers door to complete the procedure.

 

NOTE : Maximum 4 remote transmitters can be programmed.