How to Program a 1999 Toyota Camry Keyless Entry                        Remote Fob Smart Key

Step by Step How to Programming Instructions:

1.Insert the key into the ignition, and turn it to theONposition (as far as you can go without cranking the engine).

2.Press andholdthe receiverPROGRAMMING SWITCH/BUTTONfor3 seconds(see figure).In some cases the button cannot be accessed with a finger – use a pencil or similar narrow object to poke through the Programming Button access hole.For most vehicles, the receiver is located underneath either the driver or passenger front seats.On others it is behind the driver’s dash. In the case of some Camry’s, the receiver can be accessed by gently prying out the black faceplate behind the mirror control switch.The black faceplate is approx. 5 inches wide by 3 inches tall.

3.The STATUS MONITOR LED (on dash or center console) turns on for5 seconds.For some vehicles, a double chirp of the horn is heard instead of the flashing light.

4.Within5secondsof lighting the statusMONITOR LED,press and release the transmitter’sTOPorBOTTOMbutton (either button on your REMOTE CONTROL can be programmed to operate the system -the otherbuttoncanbe programmedtooperatea secondToyotavehiclewiththesame system).

5.The STATUS MONITOR LED turns off, the Piezo chirper chirps once, and the exterior lights flash once.In some cases, the only response is a single horn chirp.

6.To program an additional remote, repeat steps 2-4.7.

7.TurnOFFthe ignition.