Toyota HiLux N60 2000-2002

RS3200 (TVIP)

DEALER FITTED REMOTE KEYLESS ENTRY PROGRAMMING

NOTE : Maximum of 4 remote transmitters can be programmed.

NOTE : When a new remote transmitter it will be programmed in normal mode, additional options for this system

can be setup by referring to the main operating manual of this system.

Open the drivers door and remove the ignition key.

The programming steps must be performed within 40

Insert the key into the ignition 2

Close then open the drivers door 2

Insert the key into the ignition 1

Close then open the drivers door 2

Insert the key into the ignition and leave it in.

Close the drivers

Turn the ignition key from LOCK to ON, and then back to LOCK

Remove the key.

The tail/rear lights will flash once, the sounder will sound once and the doors will LOCK and UNLOCK.

Press the LOCK and UNLOCK button once together on the remote transmitter to be programmed.

Press the LOCK button on the remote transmitter.

The tail/rear lights will flash once, the sounder will sound once and the doors will LOCK and UNLOCK.

Repeat steps 12 to 14 for any additional remote transmitters.

Open the drivers

TO ERASE AND PROGRAM EXISTING REMOTE TRANSMIITERS

Open the drivers door and remove the ignition key.

The programming steps must be performed within 40

Insert the key into the ignition 2

Close then open the drivers door 2

Insert the key into the ignition 1

Close then open the drivers door 2

Insert the key into the ignition and leave it in.

Close the drivers

Turn the ignition key from LOCK to ON, and then back to LOCK position 2

REMOVE the key.

The tail/rear lights will flash once, the sounder will sound once and the doors will LOCK and UNLOCK.

PRESS the LOCK and UNLOCK button once together on the remote transmitter to be programmed.

PRESS the LOCK button on the remote transmitter.

The tail/rear lights will flash once, the sounder will sound once and the doors will LOCK and UNLOCK.

Repeat steps 12 to 14 for any additional remote transmitters.

OPEN the drivers

LOCK and UNLOCK the doors using the drivers door LOCK button 5

Insert key into ignition and turn to the ON position 2 times, then remove the key.

LOCKS should cycle from LOCK to UNLOCK to confirm programming.

Press the LOCK and UNLOCK button together on the remote transmitter for 1

The LOCKS should cycle LOCK to UNLOCK to confirm programming.