Free, program your remote

                                        Mitsubishi Galant 2000-2007



Procedure

 

Ensure the doors lock and unlock using the key.

 

With ignition OFF connect pins 1 and 4 of the OBD connector together using a suitable jumper pin.

 

Within 10 seconds of connecting the jumper switch PRESS the HAZARD button 6 times.

 

The doors will LOCK and UNLOCK.

 

PRESS and release the LOCK button on the first remote transmitter.

 

Within 10 seconds PRESS the LOCK button of the remote TWICE.

 

The doors will LOCK and UNLOCK.

 

Repeat steps 5 to 7 for all additional remote transmitters.

 

Check all remote transmitters for correct operation.

 

 Remove the jumper connection.

 

NOTE : ALL remote transmitters must be programmed within 1 minute of entering the programming mode.

 

NOTE : Programming mode will end when 4 transmitters are programmed, Jumper is disconnected or Ignition is switched ON.

 

NOTE : ALL remote transmitters programmed, will be erased once programming mode has been enabled.