Toyota Highlander 2001-2007

NOTE : Make sure the drivers door is open and unlocked and Key is out of the ignition.

INSERT and REMOVE the key from the ignition key cylinder twice within 5 seconds.

CLOSE and OPEN the drivers door twice within 40

INSERT the key into the ignition and remove it, do not turn.

CLOSE and OPEN the drivers door twice within 40

INSERT the key into the ignition.

CLOSE the door.

Turn the ignition switch from LOCK to ON and back to LOCK at about 1 second intervals

to select the desired mode :

NOTE : 1 time for ADD.

NOTE : 2 times for REWRITE.

NOTE : 3 times for CONFIRMATION.

NOTE : 5 times for PROHIBITION.

Remove the key from the ignition.

NOTE : To confirm your selection of all modes except CONFIRMATION, the power locks

will now cycle LOCK to UNLOCK a number of times corresponding the mode selected.

NOTE : If CONFIRMATION mode has been selected, the power door locks will now cycle

in 2 seconds intervals) a number of times corresponding to the number of transmitters currently registered.

Opening the door will complete the procedure.

NOTE : If PROHIBITION mode has been selected, opening the door will complete the procedure.

For ADD or REWRITE modes, within 20 seconds of Door Lock confirmation proceed as follows :

(a) Press both transmitter LOCK and UNLOCK buttons simultaneously between 1 and 1.5 seconds and release.

(b) Within 3 seconds of step (a), press the transmitter LOCK button for more than 1 second and release.

(c) If the transmitter has been successfully programmed, the power locks will cycle LOCK to UNLOCK

once at this time. If there are problems with the procedure up to this point, the locks

will cycle twice, in which case you must go back and repeat the above steps (a) and (b).

(d) If multiple transmitters are to be programmed, repeat the above steps (a) to (c).

Open the drivers door to complete the procedure.