Subaru Legacy 1999-2004

Procedure

PROGRAMMING

NOTE : Maximum 4 remote transmitters can be programmed.

PRESS remote transmitter UNLOCK button to ensure alarm is deactivated.

OPEN the drivers door.

Enter the vehicle and CLOSE the drivers

Switch ignition from LOCK to ON 10 times within 15

The HORN will sound to indicate programming mode.

Within 45 seconds OPEN and CLOSE the drivers door once..

PRESS the LOCK or UNLOCK button on the remote transmitters to be programmed.

The HORN will sound twice to indicate programming is successful.

Repeat step 7 and 8 for all remote transmitters.

Remove ignition key from ignition, the HORN should sound 3 times to indicate end of programming mode.

NOTE : To delete any existing remote transmitters from the system, you must program the new remote transmitters to fill the memory up, so if you have only one remote transmitter then you must program it 4 times to fill in all the memory slots. If you have 2 remote transmitters then you must program each one twice.

SYNCHRONISATION

Press remote transmitter LOCK or UNLOCK button 6 times.

Check remote transmitter for operation.