Mazda 6 2002-2008

Procedure

REMOTE CONTROL REGISTRATION

NOTE : All transmitters will need to be obtained from the customer as all transmitters (new or existing) are programmed at one time. If a transmitter is not programmed during this procedure, it will become inoperative.

NOTE : On 2006 model year MX-5 Miata and Mazda5, two types of keyless entry systems have been introduced, each having a different procedure for registering transmitters. To identity which type applies, perform the following steps:

1. Remove key from steering lock and CLOSE all doors and boot or trunk.
2. OPEN driver side door.
3. INSERT key into steering lock.
4. Repeat the following three times:
5. SWITCH ignition switch to ON position, then back to LOCK position.
6. CLOSE and CLOSE driver side door three times (then leave the door open)
7. CLOSE the driver side door.
8. Do the lock actuators perform the LOCK UNLOCK cycle TWICE.

                                       NO      :           TYPE A system.

                                       YES     :           TYPE B system.

TYPE A PROCEDURE

1. REMOVE key from ignition.
2. CLOSE all doors and boot/trunk.
3. OPEN drivers door.
4. INSERT key into ignition, then switch ignition ON and back to LOCK 3 times.
5. Leave key in ignition.
6. CLOSE and OPEN drivers door 3 times and then leave door OPEN.
7. The door locks should LOCK and UNLOCK to confirm programming mode.
8. PRESS the UNLOCK button on the first remote transmitter 2 times.
9. The door locks should cycle LOCK to UNLOCK to confirm programming.
10.  Repeat step 8 and 9 for any additional remote transmitters.
11.  Check all remote transmitters for operation.

TYPE B PROCEDURE

1. REMOVE key from ignition.
2. CLOSE all doors and boot/trunk.
3. OPEN drivers door.
4. INSERT key into ignition, then switch ignition ON and back to LOCK 3 times.
5. Leave key in ignition.
6. CLOSE and OPEN drivers door 3 times and then leave door OPEN.
7. The door locks should LOCK and UNLOCK to confirm programming mode.
8. PRESS ANY button on the first remote transmitter 2 times.
9. The door locks should cycle LOCK to UNLOCK to confirm programming.
10.  Repeat step 8 and 9 for any additional remote transmitters.
11.  Check all remote transmitters for operation.

NOTE :  Always program three remote transmitters as the programming mode terminates after 3 remote transmitters are programmed. The same programmed transmitter can be programmed two or three times to allow the three memory slots to be programmed.

NOTE : A maximum of three remote transmitters can be programmed.

NOTE : When programming the remote, verify that other transmitters are not being operated in the vicinity.

NOTE : If a button other than the transmitter UNLOCK button is operated, the programming operation is disabled and the programming mode is cancelled.