Toyota HiLux AN120/AN130 2015-2016

Ensure key is not in ignition switch.

INSERT key into ignition.

NOTE : Do not turn ignition on or remove key as registration will be cancelled.

SWITCH ignition from OFF to ON5 times within 10 seconds leaving it in the ON

NOTE : The security light assembly will illuminate.

OPEN and CLOSE the drivers door ONCE and SWITCH the ignition from ON to OFF once within 30

Now perform operation 4 as required :-

1. ADDMODE : Perform step 4 ONCE
2. REWRITEMODE : Perform step 4 TWICE

• SYNCHRONISATIONMODE : Perform step 4 THREE TIMES

1. ERASEMODE : Perform step 4 FOUR TIMES

Then SWITCH ignition from ON to OFF.

The response from the system will be as follows :-

1. ADDMODE : HORN sounds ONCE and HAZARD lights FLASH ONCE.
2. ADDMODE : HORN sounds TWICE and HAZARD lights FLASH TWICE.

• ADDMODE : HORN sounds THREE times and HAZARD lights FLASH THREE

1. ADDMODE : HORN sounds FIVE times and HAZARD lights FLASH FIVE

NOTE : If ERASE has been selected, then the procedure is now complete.

PRESS the LOCK and UNLOCK buttons together on the remote transmitter to be deleted, added or syncronised.

PRESS the LOCK or UNLOCK button ONCE.

CHECK the response above to ensure confirmation is correct.

OPEN the door.

INSERT key into ignition.

SWITCH ignition ON to close procedure.